Configuring Split Horizon; Configuring Ospf - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 39 Configuring IP Unicast Routing
Switch(config)# router rip
Switch(config-router)# interface gigabitethernet1/0/2
Switch(config-if)# ip address 10.1.5.1 255.255.255.0
Switch(config-if)# ip summary-address rip 10.2.0.0 255.255.0.0
Switch(config-if)# no ip split-horizon
Switch(config-if)# exit
Switch(config)# router rip
Switch(config-router)# network 10.0.0.0
Switch(config-router)# neighbor 2.2.2.2 peer-group mygroup
Switch(config-router)# end

Configuring Split Horizon

Routers connected to broadcast-type IP networks and using distance-vector routing protocols normally
use the split-horizon mechanism to reduce the possibility of routing loops. Split horizon blocks
information about routes from being advertised by a router on any interface from which that information
originated. This feature can optimize communication among multiple routers, especially when links are
broken.
Note In general, we do not recommend disabling split horizon unless you are certain that your application
requires it to properly advertise routes.
Beginning in privileged EXEC mode, follow these steps to disable split horizon on the interface:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 ip address ip-address subnet-mask
Step 4
no ip split-horizon
Step 5 end
Step 6 show ip interface interface-id
Step 7 copy running-config startup-config
To enable the split horizon mechanism, use the ip split-horizon interface configuration command.

Configuring OSPF

This section briefly describes how to configure Open Shortest Path First (OSPF). For a complete
description of the OSPF commands, see the "OSPF Commands" chapter of the Cisco IOS IP Command
Reference, Volume 2 of 3: Routing Protocols, Release 12.2.
Note OSPF classifies different media into broadcast, nonbroadcast, and point-to-point networks. The switch
supports broadcast (Ethernet, Token Ring, and FDDI) and point-to-point networks (Ethernet interfaces
configured as point-to-point links).
OL-13270-06
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the interface to
configure.
Configure the IP address and the IP subnet.
Disable split horizon on the interface.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring OSPF
39-25