Cisco WS-CBS3032-DEL Software Configuration Manual page 1067

Chapter 40 Configuring IPv6 Unicast Routing
Beginning in privileged EXEC mode, follow these steps to assign an IPv6 address to a Layer 3 interface
and enable IPv6 routing:
Command
Step 1 configure terminal
Step 2
sdm prefer dual-ipv4-and-ipv6 {default |
routing | vlan}
Step 3 end
Step 4
reload
Step 5 configure terminal
Step 6 interface interface-id
Step 7 no switchport
Step 8 ipv6 address ipv6-prefix/prefix length eui-64
or
ipv6 address ipv6-address/prefix length
or
ipv6 address ipv6-address link-local
or
ipv6 enable
Step 9 exit
Step 10 ip routing
Step 11 ipv6 unicast-routing
Step 12
end
Step 13 show ipv6 interface interface-id
Step 14 copy running-config startup-config
OL-13270-06
Purpose
Enter global configuration mode.
Select an SDM template that supports IPv4 and IPv6.
• default—Set the switch to the default template to balance
system resources.
• routing—Set the switch to the routing template to support
IPv4 and IPv6 routing, including IPv4 policy-based routing.
vlan—Maximize VLAN configuration on the switch with
•
no routing supported in hardware.
Return to privileged EXEC mode.
Reload the operating system.
Enter global configuration mode after the switch reloads.
Enter interface configuration mode, and specify the Layer 3
interface to configure. The interface can be a physical interface,
a switch virtual interface (SVI), or a Layer 3 EtherChannel.
Remove the interface from Layer 2 configuration mode (if it is a
physical interface).
Specify a global IPv6 address with an extended unique identifier
(EUI) in the low-order 64 bits of the IPv6 address. Specify only
the network prefix; the last 64 bits are automatically computed
from the switch MAC address. This enables IPv6 processing on
the interface.
Manually configure an IPv6 address on the interface.
Specify a link-local address on the interface to be used instead
of the link-local address that is automatically configured when
IPv6 is enabled on the interface. This command enables IPv6
processing on the interface.
Automatically configure an IPv6 link-local address on the
interface, and enable the interface for IPv6 processing. The
link-local address can only be used to communicate with nodes
on the same link.
Return to global configuration mode.
Enable IP routing on the switch.
Enable forwarding of IPv6 unicast data packets.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring IPv6
40-13