Cisco WS-CBS3032-DEL Software Configuration Manual page 886

Configuring Standard QoS
Command
Step 3
match {access-group acl-index-or-name |
ip dscp dscp-list | ip precedence
ip-precedence-list}
Step 4 match protocol [ip | ipv6]
Step 5 exit
Step 6 exit
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
37-66
Purpose
Defines the match criterion to classify traffic.
By default, no match criterion is defined.
Only one match criterion per class map is supported, and only one ACL
per class map is supported.
• For access-group acl-index-or-name, specify the number or name
of the ACL.
• For ip dscp dscp-list, enter a list of up to eight IP DSCP values to
match against incoming packets. Separate each value with a space.
The range is 0 to 63.
For ip precedence ip-precedence-list, enter a list of up to eight
•
IP-precedence values to match against incoming packets. Separate
each value with a space. The range is 0 to 7.
(Optional) Specifies the IP protocol to which the class map applies.
Use the argument ip to specify IPv4 traffic, and ipv6 to specify
•
IPv6 traffic.
When you use the match protocol command, only the match-all
•
keyword is supported for the first level class map.
This command is available only when the dual IPv4 and IPv6
Note
SDM template is configured.
You can use the match protocol command with the match ip dscp or
match precedence commands, but not with the match access-group
command.
For more information about the match protocol command, see the
Cisco IOS Quality of Service Solutions Command
Returns to class-map configuration mode.
Returns to global configuration mode.
Chapter 37 Configuring QoS
Reference.
OL-13270-06