Configuring Ip Multicast Routing - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring IP Multicast Routing

This chapter describes how to configure IP multicast routing on the switch. IP multicasting is a more
efficient way to use network resources, especially for bandwidth-intensive services such as audio and
video. IP multicast routing enables a host (source) to send packets to a group of hosts (receivers)
anywhere within the IP network by using a special form of IP address called the IP multicast group
address. The sending host inserts the multicast group address into the IP destination address field of the
packet, and IP multicast routers and multilayer switches forward incoming IP multicast packets out all
interfaces that lead to members of the multicast group. Any host, regardless of whether it is a member
of a group, can send to a group. However, only the members of a group receive the message.
To use this feature, the switch or stack master must be running the IP services feature set. To use the PIM
stub routing feature, the switch or stack master can be running the IP base image.
Unless otherwise noted, the term switch refers to a standalone switch and to a switch stack.
This chapter consists of these sections:
Understanding Cisco's Implementation of IP Multicast Routing, page 45-2
•
Multicast Routing and Switch Stacks, page 45-10
•
Configuring IP Multicast Routing, page 45-11
•
Configuring Advanced PIM Features, page 45-39
•
Configuring Optional IGMP Features, page 45-43
•
• Configuring Optional Multicast Routing Features, page 45-48
• Configuring Basic DVMRP Interoperability Features, page 45-53
• Configuring Advanced DVMRP Interoperability Features, page 45-58
Monitoring and Maintaining IP Multicast Routing, page 45-66
•
For information on configuring the Multicast Source Discovery Protocol (MSDP), see
"Configuring MSDP."
OL-13270-06
C H A P T E R
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
45
Chapter 46,
45-1