C H A P T E R 26 Configuring Port-Based Traffic Control; Understanding Storm Control - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Storm Control

Understanding Storm Control

Storm control prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm
on one of the physical interfaces. A LAN storm occurs when packets flood the LAN, creating excessive
traffic and degrading network performance. Errors in the protocol-stack implementation, mistakes in
network configurations, or users issuing a denial-of-service attack can cause a storm.
Storm control (or traffic suppression) monitors packets passing from an interface to the switching bus
and determines if the packet is unicast, multicast, or broadcast. The switch counts the number of packets
of a specified type received within the 1-second time interval and compares the measurement with a
predefined suppression-level threshold.
Storm control uses one of these methods to measure traffic activity:
•
•
•
With each method, the port blocks traffic when the rising threshold is reached. The port remains blocked
until the traffic rate drops below the falling threshold (if one is specified) and then resumes normal
forwarding. If the falling suppression level is not specified, the switch blocks all traffic until the traffic
rate drops below the rising suppression level. In general, the higher the level, the less effective the
protection against broadcast storms.
When the storm control threshold for multicast traffic is reached, all multicast traffic except control
Note
traffic, such as bridge protocol data unit (BDPU) and Cisco Discovery Protocol (CDP) frames, are
blocked.However, the switch does not differentiate between routing updates, such as OSPF, and regular
multicast data traffic, so both types of traffic are blocked.
The graph in
The example can also be applied to multicast and unicast traffic. In this example, the broadcast traffic
being forwarded exceeded the configured threshold between time intervals T1 and T2 and between T4
and T5. When the amount of specified traffic exceeds the threshold, all traffic of that kind is dropped for
the next time period. Therefore, broadcast traffic is blocked during the intervals following T2 and T5.
At the next time interval (for example, T3), if broadcast traffic does not exceed the threshold, it is again
forwarded.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
26-2
Bandwidth as a percentage of the total available bandwidth of the port that can be used by the
broadcast, multicast, or unicast traffic
Traffic rate in packets per second at which broadcast, multicast, or unicast packets are received
Traffic rate in packets per second and for small frames. This feature is enabled globally. The
threshold for small frames is configured for each interface. (Cisco IOS Release 12.2(44)SE or later)
Figure 26-1 shows broadcast traffic patterns on an interface over a given period of time.
Chapter 26 Configuring Port-Based Traffic Control
OL-13270-06