Cisco WS-CBS3032-DEL Software Configuration Manual page 459

Chapter 17 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Command
Step 5
l2protocol-tunnel
shutdown-threshold [point-to-point
[pagp | lacp | udld]] value
Step 6 l2protocol-tunnel drop-threshold
[point-to-point [pagp | lacp | udld]]
value
Step 7 no cdp enable
Step 8 spanning-tree bpdufilter enable
Step 9
exit
Step 10
errdisable recovery cause l2ptguard (Optional) Configure the recovery mechanism from a Layer 2
Step 11 l2protocol-tunnel cos value
Step 12 end
Step 13
show l2protocol
Step 14
copy running-config startup-config
Use the no l2protocol-tunnel [point-to-point [pagp | lacp | udld]] interface configuration command to
disable point-to-point protocol tunneling for one of the Layer 2 protocols or for all three. Use the no
l2protocol-tunnel shutdown-threshold [point-to-point [pagp | lacp | udld]] and the no
l2protocol-tunnel drop-threshold [[point-to-point [pagp | lacp | udld]] commands to return the
shutdown and drop thresholds to the default settings.
OL-13270-06
Purpose
(Optional) Configure the threshold for packets-per-second accepted for
encapsulation. The interface is disabled if the configured threshold is
exceeded. If no protocol option is specified, the threshold applies to each of
the tunneled Layer 2 protocol types. The range is 1 to 4096. The default is
to have no threshold configured.
If you also set a drop threshold on this interface, the
Note
shutdown-threshold value must be greater than or equal to the
drop-threshold value.
(Optional) Configure the threshold for packets-per-second accepted for
encapsulation. The interface drops packets if the configured threshold is
exceeded. If no protocol option is specified, the threshold applies to each of
the tunneled Layer 2 protocol types. The range is 1 to 4096. The default is
to have no threshold configured.
If you also set a shutdown threshold on this interface, the
Note
drop-threshold value must be less than or equal to the
shutdown-threshold value.
Disable CDP on the interface.
Enable BPDU filtering on the interface.
Return to global configuration mode.
maximum-rate error so that the interface is re-enabled and can try again.
Errdisable recovery is disabled by default; when enabled, the default time
interval is 300 seconds.
(Optional) Configure the CoS value for all tunneled Layer 2 PDUs. The
range is 0 to 7; the default is the default CoS value for the interface. If none
is configured, the default is 5.
Return to privileged EXEC mode.
Display the Layer 2 tunnel ports on the switch, including the protocols
configured, the thresholds, and the counters.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring Layer 2 Protocol Tunneling
17-15