Table of Contents
Advertisement
Chapter 39
Configuring IP Unicast Routing
User Interface for Syslog
Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for syslog. For
complete syntax and usage information for the commands, refer to the switch command reference for
this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
Step 1
configure terminal
Step 2
logging on
Step 3
logging host ip-address vrf vrf-name
Step 4
logging buffered logging buffered size
debugging
Step 5
logging trap debugging
Step 6
logging facility facility
Step 7
end
User Interface for Traceroute
Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for traceroute.
For complete syntax and usage information for the commands, refer to the switch command reference
for this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
traceroute vrf vrf-name ipaddress
User Interface for FTP and TFTP
So that FTP and TFTP are VRF-aware, you must configure command-line interface (CLI) commands for
FTP/TFTP. For example, if you want to use a VRF table that is attached to an interface, say E1/0, you
need to configure the CLI ip [t]ftp source-interface E1/0 to inform [t]ftp to use a specific routing table.
In this example, the VRF table looks up the destination IP address. These changes are
backward-compatible and do not affect existing behavior. That is, you can use the source-interface CLI
to send packets out a particular interface even if no VRF is configured on that interface.
To specify the source IP address for FTP connections, use the ip ftp source-interface show mode
command. To use the address of the interface where the connection is made, use the no form of this
command.
Command
Step 1
configure terminal
Step 2
ip ftp source-interface interface-type
interface-number
Step 3
end
OL-13270-06
Purpose
Enter global configuration mode.
Enable or temporarily disable logging of storage-router event message.
Specify the host address of the syslog server where logging messages
are to be sent.
Log messages to an internal buffer.
Limit the logging messages sent to the syslog server.
Send system logging messages to a logging facility.
Return to privileged EXEC mode.
Purpose
Specify the name of a VPN VRF in which to find the destination
address.
Purpose
Enter global configuration mode.
Specify the source IP address for FTP connections.
Return to privileged EXEC mode.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring Multi-VRF CE
39-87
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
