Cisco WS-CBS3032-DEL Software Configuration Manual page 790

Configuring IPv4 ACLs
Figure 35-3
Human Resources
172.20.128.0-31
This example uses a standard ACL to filter traffic coming into blade server B from a port, permitting
traffic only from Accounting's source addresses 172.20.128.64 to 172.20.128.95. The ACL is applied to
traffic coming out of routed Port 1 from the specified source address.
Switch(config)# access-list 6 permit 172.20.128.64 0.0.0.31
Switch(config)# end
Switch# show access-lists
Standard IP access list 6
10 permit 172.20.128.64, wildcard bits 0.0.0.31
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip access-group 6 out
This example uses an extended ACL to filter traffic coming from blade server B into a port, permitting
traffic from any source address (in this case Server B) to only the Accounting destination addresses
172.20.128.64 to 172.20.128.95. The ACL is applied to traffic going into routed Port 1, permitting it to
go only to the specified destination addresses. Note that with extended ACLs, you must enter the
protocol (IP) before the source and destination information.
Switch(config)# access-list 106 permit ip any 172.20.128.64 0.0.0.31
Switch(config)# end
Switch# show access-lists
Extended IP access list 106
10 permit ip any 172.20.128.64 0.0.0.31
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip access-group 106 in
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
35-24
Using Router ACLs to Control Traffic
Blade
server A server B
Port 2 Port 1
Chapter 35 Configuring Network Security with ACLs
Blade
Accounting
172.20.128.64-95
OL-13270-06