Default Bgp Configuration - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 39 Configuring IP Unicast Routing
•
•
•
•
For detailed descriptions of BGP configuration, see the "Configuring BGP" chapter in the "IP Routing
Protocols" part of the Cisco IOS IP Configuration Guide, Release 12.2. For details about specific
commands, see the Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release 12.2.
For a list of BGP commands that are visible but not supported by the switch, see
"Unsupported Commands in Cisco IOS Release 12.2(58)SE."

Default BGP Configuration

Table 39-9
commands in the Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release 12.2.
Table 39-9 Default BGP Configuration
Feature
Aggregate address
Autonomous-system path access
list
Auto summary
Best path
BGP community list
BGP confederation identifier/peers
BGP fast external fallover
BGP local preference
BGP network
BGP route dampening
BGP router ID
Default information originate
(protocol or network redistribution)
OL-13270-06
Configuring Routing Domain Confederations, page 39-65
Configuring BGP Route Reflectors, page 39-66
Configuring Route Dampening, page 39-67
Monitoring and Maintaining BGP, page 39-68
shows the default BGP configuration. For the defaults for all characteristics, see the specific
Default Setting
Disabled: None defined.
None defined.
Enabled.
The router considers as-path in choosing a route and does not compare similar
•
routes from external BGP peers.
• Compare router ID: Disabled.
Number: None defined. When you permit a value for the community number, the
•
list defaults to an implicit deny for everything else that has not been permitted.
Format: Cisco IOS default format (32-bit number).
•
Identifier: None configured.
•
Peers: None identified.
•
Enabled.
100. The range is 0 to 4294967295 with the higher value preferred.
None specified; no backdoor route advertised.
Disabled by default. When enabled:
Half-life is 15 minutes.
•
Re-use is 750 (10-second increments).
•
Suppress is 2000 (10-second increments).
•
• Max-suppress-time is 4 times half-life; 60 minutes.
The IP address of a loopback interface if one is configured or the highest IP address
configured for a physical interface on the router.
Disabled.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring BGP
Appendix B,
39-49