Default Ospf Configuration - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring OSPF

Default OSPF Configuration

Table 39-5
Table 39-5
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
NSF
NSF capability
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
39-28
shows the default OSPF configuration.
Default OSPF Configuration
1
awareness
Default Setting
Cost: No default cost predefined.
Resend interval: 5 seconds.
Send delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mb/s.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
2
Enabled . Allows Layer 3 switches to continue forwarding
packets from a neighboring NSF-capable router during hardware
or software changes.
Disabled.
The switch stack supports OSPF NSF-capable routing
Note
for IPv4.
Chapter 39 Configuring IP Unicast Routing
OL-13270-06