Cisco WS-CBS3032-DEL Software Configuration Manual page 1035

Chapter 39 Configuring IP Unicast Routing
Switch(config-router-af)# neighbor 38.0.0.3 remote-as 100
Switch(config-router-af)# neighbor 38.0.0.3 activate
Switch(config-router-af)# network 8.8.1.0 mask 255.255.255.0
Switch(config-router-af)# end
Configuring Switch D
Switch D belongs to VPN 1. Configure the connection to Switch A by using these commands.
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# ip routing
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# no switchport
Switch(config-if)# ip address 208.0.0.20 255.255.255.0
Switch(config-if)# exit
Switch(config)# router ospf 101
Switch(config-router)# network 208.0.0.0 0.0.0.255 area 0
Switch(config-router)# end
Configuring Switch F
Switch F belongs to VPN 2. Configure the connection to Switch A by using these commands.
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# ip routing
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# switchport mode trunk
Switch(config-if)# no ip address
Switch(config-if)# exit
Switch(config)# interface vlan118
Switch(config-if)# ip address 118.0.0.11 255.255.255.0
Switch(config-if)# exit
Switch(config)# router ospf 101
Switch(config-router)# network 118.0.0.0 0.0.0.255 area 0
Switch(config-router)# end
Configuring PE Switch B
When used on switch B (the PE router), these commands configure only the connections to the CE
device, Switch A.
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ip vrf v1
Router(config-vrf)# rd 100:1
Router(config-vrf)# route-target export 100:1
Router(config-vrf)# route-target import 100:1
Router(config-vrf)# exit
Router(config)# ip vrf v2
Router(config-vrf)# rd 100:2
Router(config-vrf)# route-target export 100:2
Router(config-vrf)# route-target import 100:2
Router(config-vrf)# exit
OL-13270-06
End with CNTL/Z.
End with CNTL/Z.
End with CNTL/Z.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring Multi-VRF CE
39-93