Configuring Snmp Notifications - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring SNMP

Configuring SNMP Notifications

A trap manager is a management station that receives and processes traps. Traps are system alerts that
the switch generates when certain events occur. By default, no trap manager is defined, and no traps are
sent. Switches running this Cisco IOS release can have an unlimited number of trap managers.
Note Many commands use the word traps in the command syntax. Unless there is an option in the command
to select either traps or informs, the keyword traps refers to traps, informs, or both. Use the snmp-server
host global configuration command to specify whether to send SNMP notifications as traps or informs.
Table 33-5
traps and configure a trap manager to receive them.
Table 33-5
Notification Type
Keyword
bgp
bridge
cluster
config
copy-config
cpu-threshold
entity
envmon
flash
fru-ctrl
hsrp
ipmulticast
mac-notification
msdp
ospf
pim
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
33-12
describes the supported switch traps (notification types). You can enable any or all of these
Switch Notification Types
Description
Generates Border Gateway Protocol (BGP) state change traps. This option is
only available when the IP services feature set is enabled.
Generates STP bridge MIB traps.
Generates a trap when the cluster configuration changes.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Allow CPU-related traps.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, status, supply, temperature.
Generates SNMP FLASH notifications. In a switch stack, you can optionally
enable notification for flash insertion or removal, which would cause a trap to
be issued whenever a switch in the stack is removed or inserted (physical
removal, power cycle, or reload).
Generates entity field-replaceable unit (FRU) control traps. In the switch
stack, this trap refers to the insertion or removal of a switch in the stack.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Generates a trap for MAC address notifications.
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable
any or all of these traps: Cisco specific, errors, link-state advertisement, rate
limit, retransmit, and state changes.
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
enable any or all of these traps: invalid PIM messages, neighbor changes, and
rendezvous point (RP)-mapping changes.
Chapter 33 Configuring SNMP
OL-13270-06