Configuring Mhsrp - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 41 Configuring HSRP and VRRP
Configuring HSRP
Use the no standby [group-number] priority priority [preempt [delay delay]] and no standby
[group-number] [priority priority] preempt [delay delay] interface configuration commands to restore
default priority, preempt, and delay values.
Use the no standby [group-number] track type number [interface-priority] interface configuration
command to remove the tracking.
This example activates a port, sets an IP address and a priority of 120 (higher than the default value),
and waits for 300 seconds (5 minutes) before attempting to become the active router:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# no switchport
Switch(config-if)# standby ip 172.20.128.3
Switch(config-if)# standby priority 120 preempt delay 300
Switch(config-if)# end

Configuring MHSRP

To enable MHSRP and load-balancing, you configure two routers as active routers for their groups, with
virtual routers as standby routers. This example shows how to enable the MHSRP configuration shown
in Figure 41-2 on page 41-5. You need to enter the standby preempt interface configuration command
on each HSRP interface so that if a router fails and comes back up, the preemption occurs and restores
load-balancing.
Router A is configured as the active router for group 1, and Router B is configured as the active router
for group 2. The HSRP interface for Router A has an IP address of 10.0.0.1 with a group 1 standby
priority of 110 (the default is 100). The HSRP interface for Router B has an IP address of 10.0.0.2 with
a group 2 standby priority of 110.
Group 1 uses a virtual IP address of 10.0.0.3 and group 2 uses a virtual IP address of 10.0.0.4.
Router A Configuration
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# no switchport
Switch(config-if)# ip address 10.0.0.1 255.255.255.0
Switch(config-if)# standby 1 ip 10.0.0.3
Switch(config-if)# standby 1 priority 110
Switch(config-if)# standby 1 preempt
Switch(config-if)# standby 2 ip 10.0.0.4
Switch(config-if)# standby 2 preempt
Switch(config-if)# end
Router B Configuration
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# no switchport
Switch(config-if)# ip address 10.0.0.2 255.255.255.0
Switch(config-if)# standby 1 ip 10.0.0.3
Switch(config-if)# standby 1 preempt
Switch(config-if)# standby 2 ip 10.0.0.4
Switch(config-if)# standby 2 priority 110
Switch(config-if)# standby 2 preempt
Switch(config-if)# end
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
41-10
OL-13270-06