Default Hsrp Configuration; Hsrp Configuration Guidelines - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring HSRP
•
•

Default HSRP Configuration

Table 41-1
Table 41-1
Feature
HSRP version
HSRP groups
Standby group number
Standby MAC address
Standby priority
Standby delay
Standby track interface priority
Standby hello time
Standby holdtime

HSRP Configuration Guidelines

Follow these guidelines when configuring HSRP:
•
•
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
41-6
Configuring HSRP Authentication and Timers, page 41-11
Enabling HSRP Support for ICMP Redirect Messages, page 41-12
shows the default HSRP configuration.
Default HSRP Configuration
HSRP can be configured on a maximum of 32 VLAN or routing interfaces.
In the procedures, the specified interface must be one of these Layer 3 interfaces:
– Routed port: a physical port configured as a Layer 3 port by entering the no switchport
interface configuration command.
– SVI: a VLAN interface created by using the interface vlan vlan_id global configuration
command and by default a Layer 3 interface.
Etherchannel port channel in Layer 3 mode: a port-channel logical interface created by using
–
the interface port-channel port-channel-number global configuration command and binding
the Ethernet interface into the channel group. For more information, see the
Layer 3 EtherChannels" section on page
All Layer 3 interfaces must have IP addresses assigned to them. See the
Interfaces" section on page
HSRPv2 and HSRPv1 can be configured on the same switch if HSRPv2 is configured on different
interfaces than those on which HSRPv1 is configured.
The version of an HSRP group can be changed from HSRPv2 to HSRPv1 only if the group number
is less than 256.
If you change the HSRP version on an interface, each HSRP group resets because it now has a new
virtual MAC address.
Default Setting
Version 1
None configured
0
System assigned as: 0000.0c07.acXX, where XX is the HSRP
group number
100
0 (no delay)
10
3 seconds
10 seconds
38-15.
11-25.
Chapter 41 Configuring HSRP and VRRP
"Configuring
"Configuring Layer 3
OL-13270-06