Table of Contents
Advertisement
Configuring IP SLAs Operations
Beginning in privileged EXEC mode, follow these steps to configure an ICMP echo operation on the
source device:
Command
Step 1
configure terminal
Step 2
ip sla operation-number
Step 3
icmp-echo {destination-ip-address
| destination-hostname} [source-ip
{ip-address | hostname} |
source-interface interface-id]
Step 4
frequency seconds
Step 5
exit
Step 6
ip sla schedule operation-number
[life {forever | seconds}]
[start-time {hh:mm [:ss] [month
day | day month] | pending | now |
after hh:mm:ss] [ageout seconds]
[recurring]
Step 7
end
Step 8
show ip sla configuration
[operation-number]
Step 9
copy running-config
startup-config
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
42-12
Purpose
Enter global configuration mode.
Create an IP SLAs operation and enter IP SLAs configuration mode.
Configure the IP SLAs operation as an ICMP Echo operation and enter ICMP
echo configuration mode.
•
destination-ip-address | destination-hostname—Specify the destination IP
address or hostname.
•
(Optional) source-ip {ip-address | hostname}—Specify the source IP
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination
(Optional) source-interface interface-id—Specify the source interface for
•
the operation.
(Optional) Set the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 seconds.
Exit UDP jitter configuration mode, and return to global configuration mode.
Configure the scheduling parameters for an individual IP SLAs operation.
•
operation-number—Enter the RTR entry number.
(Optional) life—Set the operation to run indefinitely (forever) or for a
•
specific number of seconds. The range is from 0 to 2147483647. The
default is 3600 seconds (1 hour)
•
(Optional) start-time—Enter the time for the operation to begin collecting
information:
To start at a specific time, enter the hour, minute, second (in 24-hour
–
notation), and day of the month. If no month is entered, the default is
the current month.
Enter pending to select no information collection until a start time is
–
selected.
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to indicate that the operation should start after
–
the entered time has elapsed.
(Optional) ageout seconds—Enter the number of seconds to keep the
•
operation in memory when it is not actively collecting information. The
range is 0 to 2073600 seconds; the default is 0 seconds (never ages out).
•
(Optional) recurring—Set the operation to automatically run every day.
Return to privileged EXEC mode.
(Optional) Display configuration values including all defaults for all IP SLAs
operations or a specified operation.
(Optional) Save your entries in the configuration file.
Chapter 42
Configuring Cisco IOS IP SLAs Operations
OL-13270-06
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
