Configuring A Static Multicast Group - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring IPv6 MLD Snooping
Command
Step 1 configure terminal
Step 2
ipv6 mld snooping
Step 3 ipv6 mld snooping vlan vlan-id
Step 4 end
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
To disable MLD snooping on a VLAN interface, use the no ipv6 mld snooping vlan vlan-id global
configuration command for the specified VLAN number.

Configuring a Static Multicast Group

Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also statically configure
an IPv6 multicast address and member ports for a VLAN.
Beginning in privileged EXEC mode, follow these steps to add a Layer 2 port as a member of a multicast
group:
Command
Step 1 configure terminal
Step 2
ipv6 mld snooping vlan vlan-id static
ipv6_multicast_address interface interface-id
Step 3
end
Step 4
show ipv6 mld snooping multicast-address
user
or
show ipv6 mld snooping multicast-address
vlan vlan-id user
Step 5 copy running-config startup-config
To remove a Layer 2 port from the multicast group, use the no ipv6 mld snooping vlan vlan-id static
mac-address interface interface-id global configuration command. If all member ports are removed
from a group, the group is deleted.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
25-8
Purpose
Enter global configuration mode.
Globally enable MLD snooping on the switch.
Enable MLD snooping on the VLAN.The VLAN ID range is 1 to 1001 and
1006 to 4094.
MLD snooping must be globally enabled for VLAN snooping to be
Note
enabled.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode
Statically configure a multicast group with a Layer 2 port as a
member of a multicast group:
• vlan-id is the multicast group VLAN ID. The VLAN ID range
is 1 to 1001 and 1006 to 4094.
• ipv6_multicast_address is the 128-bit group IPv6 address.
The address must be in the form specified in RFC 2373.
interface-id is the member port. It can be a physical interface
•
or a port channel (1 to 72).
Return to privileged EXEC mode.
Verify the static member port and the IPv6 address.
(Optional) Save your entries in the configuration file.
Chapter 25 Configuring IPv6 MLD Snooping
OL-13270-06