Chapter 47
Configuring Fallback Bridging
This example shows how to disable spanning tree on a port in bridge group 10:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# bridge group 10 spanning-disabled
Monitoring and Maintaining Fallback Bridging
To monitor and maintain the network, use one or more of the privileged EXEC commands in
Table 47-2
Command
clear bridge bridge-group
show bridge [bridge-group] group
show bridge [bridge-group] [interface-id |
mac-address | verbose]
To display the bridge-group MAC address table on a stack member, start a session from the stack master
to the stack member by using the session stack-member-number global configuration command. Enter
the show bridge [bridge-group] [interface-id | mac-address | verbose] privileged EXEC command at the
stack member prompt.
For information about the fields in these displays, see the Cisco IOS Bridging and IBM Networking
Command Reference, Volume 1 of 2, Release 12.2.
OL-13270-06
Commands for Monitoring and Maintaining Fallback Bridging
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Monitoring and Maintaining Fallback Bridging
Purpose
Removes any learned entries from the forwarding
database.
Displays details about the bridge group.
Displays MAC addresses learned in the bridge group.
Table
47-2:
47-11