Using The Crashinfo Files; Basic Crashinfo Files; Extended Crashinfo Files - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 48 Troubleshooting
Output Packets:
------------------------------------------
Packet 1
Lookup
OutptACL 50_10010A05_0A010505-00_40000014_000A0000
Port
Gi1/0/2

Using the crashinfo Files

The crashinfo files save information that helps Cisco technical support representatives to debug
problems that caused the Cisco IOS image to fail (crash). The switch writes the crash information to the
console at the time of the failure. The switch creates two types of crashinfo files:
•
•

Basic crashinfo Files

The information in the basic file includes the Cisco IOS image name and version that failed, a list of the
processor registers, and a stack trace. You can provide this information to the Cisco technical support
representative by using the show tech-support privileged EXEC command.
Basic crashinfo files are kept in this directory on the flash file system:
flash:/crashinfo/.
The filenames are crashinfo_n where n is a sequence number.
Each new crashinfo file that is created uses a sequence number that is larger than any previously existing
sequence number, so the file with the largest sequence number describes the most recent failure. Version
numbers are used instead of a timestamp because the switches do not include a real-time clock. You
cannot change the name of the file that the system will use when it creates the file. However, after the
file is created, you can use the rename privileged EXEC command to rename it, but the contents of the
renamed file will not be displayed by the show stacks or the show tech-support privileged EXEC
command. You can delete crashinfo files by using the delete privileged EXEC command.
You can display the most recent basic crashinfo file (that is, the file with the highest sequence number
at the end of its filename) by entering the show stacks or the show tech-support privileged EXEC
command. You also can access the file by using any command that can copy or display files, such as the
more or the copy privileged EXEC command.

Extended crashinfo Files

The switch creates the extended crashinfo file when the system is failing. The information in the
extended file includes additional information that can help determine the cause of the switch failure. You
provide this information to the Cisco technical support representative by manually accessing the file and
using the more or the copy privileged EXEC command.
Extended crashinfo files are kept in this directory on the flash file system:
flash:/crashinfo_ext/.
OL-13270-06
Key-Used
Vlan SrcMac
0007 XXXX.XXXX.0246
Basic crashinfo file—The switch automatically creates this file the next time you boot up the Cisco
IOS image after the failure.
Extended crashinfo file—The switch automatically creates this file when the system is failing.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Index-Hit
DstMac Cos Dscpv
0009.43A8.0147
Using the crashinfo Files
A-Data
01FFE 03000000
48-21