Table of Contents
Advertisement
Configuring EIGRP
Command
Step 9
ip summary-address eigrp
autonomous-system-number address mask
Step 10
end
Step 11
show ip protocols
Step 12
show ip protocols
Step 13
copy running-config startup-config
Configuring EIGRP Interfaces
Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
ip bandwidth-percent eigrp percent
Step 4
ip summary-address eigrp
autonomous-system-number address mask
Step 5
ip hello-interval eigrp autonomous-system-number
seconds
Step 6
ip hold-time eigrp autonomous-system-number
seconds
Step 7
no ip split-horizon eigrp autonomous-system-number (Optional) Disable split horizon to allow route information
Step 8
end
Step 9
show ip eigrp interface
Step 10
copy running-config startup-config
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
39-44
Purpose
(Optional) Configure a summary aggregate.
Return to privileged EXEC mode.
Verify your entries.
Verify your entries.
For NSF awareness, the output shows:
*** IP Routing is NSF aware ***
EIGRP NSF enabled
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
(Optional) Change the hello-time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
(Optional) Change the hold-time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
Caution
Do not adjust the hold time without consulting
Cisco technical support.
to be advertised by a router from any interface that
originated that information.
Return to privileged EXEC mode.
Display which interfaces EIGRP is active on and
information about EIGRP relating to those interfaces.
(Optional) Save your entries in the configuration file.
Chapter 39
Configuring IP Unicast Routing
OL-13270-06
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
