Table of Contents
Advertisement
Chapter 39
Configuring IP Unicast Routing
Command
Step 3
timers lsa-group-pacing seconds
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
To return to the default value, use the no timers lsa-group-pacing router configuration command.
Configuring a Loopback Interface
OSPF uses the highest IP address configured on the interfaces as its router ID. If this interface is down
or removed, the OSPF process must recalculate a new router ID and resend all its routing information
through its interfaces. If a loopback interface is configured with an IP address, OSPF uses this IP address
as its router ID, even if other interfaces have higher IP addresses. Loopback interfaces never fail, which
provides greater stability. OSPF automatically prefers a loopback interface over other interfaces, and it
chooses the highest IP address among all loopback interfaces.
Beginning in privileged EXEC mode, follow these steps to configure a loopback interface:
Command
Step 1
configure terminal
Step 2
interface loopback 0
Step 3
ip address address mask
Step 4
end
Step 5
show ip interface
Step 6
copy running-config startup-config
Use the no interface loopback 0 global configuration command to disable the loopback interface.
OL-13270-06
Purpose
Change the group pacing of LSAs.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Create a loopback interface, and enter interface configuration mode.
Assign an IP address to this interface.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring OSPF
39-37
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
