Displaying Ipv6 - Cisco WS-CBS3032-DEL Software Configuration Manual

Displaying IPv6

Displaying IPv6
For complete syntax and usage information on these commands, see the Cisco IOS command reference
publications.
Table 40-2
Table 40-2 Commands for Monitoring IPv6
Command
show ipv6 access-list
1
show ipv6 cef
show ipv6 interface interface-id
show ipv6 mtu
show ipv6 neighbors
1
show ipv6 ospf
show ipv6 prefix-list
1
show ipv6 protocols
1
show ipv6 rip
1
show ipv6 route
1
show ipv6 routers
show ipv6 static
show ipv6 traffic
1. This command is not supported on the Catalyst Switch Module 3012.
Table 40-3
Table 40-3 Commands for Displaying EIGRP IPv6 Information
Command
show ipv6 eigrp [as-number] interface
show ipv6 eigrp [as-number] neighbor
show ipv6 eigrp [as-number] traffic
show ipv6 eigrp topology [as-number | ipv6-address]
[active | all-links | detail-links | pending | summary |
zero-successors]
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
40-28
shows the privileged EXEC commands for monitoring IPv6 on the switch.
Purpose
Display a summary of access lists.
Display Cisco Express Forwarding for IPv6.
Display IPv6 interface status and configuration.
Display IPv6 MTU per destination cache.
Display IPv6 neighbor cache entries.
Display IPv6 OSPF information.
Display a list of IPv6 prefix lists.
Display IPv6 routing protocols on the switch.
Display IPv6 RIP routing protocol status.
Display the IPv6 route table entries.
Display the local IPv6 routers.
Display IPv6 static routes.
Display IPv6 traffic statistics.
shows the privileged EXEC command for displaying EIGRP IPv6 information.
Purpose
Displays information about interfaces configured for EIGRP IPv6.
Displays the neighbors discovered by EIGRP IPv6.
Displays the number of EIGRP IPv6 packets sent and received.
Displays EIGRP entries in the IPv6 topology table.
Chapter 40 Configuring IPv6 Unicast Routing
OL-13270-06