Configuring The Priority Of Incoming Data Frames - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Voice VLAN
This example shows how to configure a port connected to a Cisco IP Phone to use the CoS value to
classify incoming traffic, to use IEEE 802.1p priority tagging for voice traffic, and to use the default
native VLAN (VLAN 0) to carry all traffic:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# mls qos trust cos
Switch(config-if)# switchport voice vlan dot1p
Switch(config-if)# end
To return the port to its default setting, use the no switchport voice vlan interface configuration
command.
This example shows how to enable switchport voice detect on a Cisco IP Phone:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# switchport voice?
detect
vlan
Switch(config-if)# switchport voice detect?
cisco-phone
Switch(config-if)# switchport voice detect cisco-phone?
full-duplex
Switch(config-if)# switchport voice detect cisco-phone full-duplex
full-duplex
Switch(config-if)# end
This example shows how to disable switchport voice detect on a Cisco IP Phone:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# no switchport voice detect cisco-phone
Switch(config-if)# no switchport voice detect cisco-phone full-duplex

Configuring the Priority of Incoming Data Frames

You can connect a PC or other data device to a Cisco IP Phone port. To process tagged data traffic (in
IEEE 802.1Q or IEEE 802.1p frames), you can configure the switch to send CDP packets to instruct the
phone how to send data packets from the device attached to the access port on the Cisco IP Phone. The
PC can generate packets with an assigned CoS value. You can configure the phone to not change (trust)
or to override (not trust) the priority of frames arriving on the phone port from connected devices.
Beginning in privileged EXEC mode, follow these steps to set the priority of data traffic received from
the nonvoice port on the Cisco IP Phone:
Command
Step 1 configure terminal
Step 2 interface interface-id
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
15-6
detection enhancement keyword
VLAN for voice traffic
Cisco IP Phone
Cisco IP Phone
full duplex keyword
Purpose
Enter global configuration mode.
Specify the interface connected to the Cisco IP Phone, and enter interface
configuration mode.
Chapter 15
End with CNTL/Z.
End with CNTL/Z.
End with CNTL/Z.
Configuring Voice VLAN
OL-13270-06