Monitoring Flex Links and the MAC Address-Table Move Update Information
Beginning in privileged EXEC mode, follow these steps to configure a switch to get and process MAC
address-table move update messages:
Command
Step 1
configure terminal
Step 2
mac address-table move update receive
Step 3
end
Step 4
show mac address-table move update
Step 5
copy running-config startup config
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table Move
Update Information
Table 21-1
MAC address-table move update information.
Table 21-1
Command
show interface
[interface-id] switchport
backup
show mac address-table
move update
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
21-14
Chapter 21
shows the privileged EXEC commands for monitoring the Flex Links configuration and the
Flex Links and MAC Address-Table Move Update Monitoring Commands
Purpose
Displays the Flex Link backup interface configured for an interface or
all the configured Flex Links and the state of each active and backup
interface (up or standby mode).
Displays the MAC address-table move update information on the
switch.
Configuring Flex Links and the MAC Address-Table Move Update Feature
Purpose
Enter global configuration mode.
Enable the switch to get and process the MAC
address-table move updates.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the switch startup
configuration file.
OL-13270-06