Understanding Spanning-Tree Features - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring STP
This chapter describes how to configure the Spanning Tree Protocol (STP) on port-based VLANs on the
switch. The switch can use either the per-VLAN spanning-tree plus (PVST+) protocol based on the
IEEE 802.1D standard and Cisco proprietary extensions, or the rapid per-VLAN spanning-tree plus
(rapid-PVST+) protocol based on the IEEE 802.1w standard. A switch stack appears as a single
spanning-tree node to the rest of the network, and all stack members use the same bridge ID. Unless
otherwise noted, the term switch refers to a standalone switch and to a switch stack.
For information about the Multiple Spanning Tree Protocol (MSTP) and how to map multiple VLANs
to the same spanning-tree instance, see
spanning-tree features such as Port Fast, UplinkFast, root guard, and so forth, see
"Configuring Optional Spanning-Tree Features."
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•

Understanding Spanning-Tree Features

These sections contain this conceptual information:
•
•
•
•
•
•
•
•
•
OL-13270-06
Understanding Spanning-Tree Features, page 18-1
Configuring Spanning-Tree Features, page 18-13
Displaying the Spanning-Tree Status, page 18-24
STP Overview, page 18-2
Spanning-Tree Topology and BPDUs, page 18-3
Bridge ID, Switch Priority, and Extended System ID, page 18-4
Spanning-Tree Interface States, page 18-5
How a Switch or Port Becomes the Root Switch or Root Port, page 18-8
Spanning Tree and Redundant Connectivity, page 18-8
Spanning-Tree Address Management, page 18-9
Accelerated Aging to Retain Connectivity, page 18-9
Spanning-Tree Modes and Protocols, page 18-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
C H A P T E R
Chapter 19, "Configuring MSTP."
18
For information about other
Chapter 20,
18-1