Cisco WS-CBS3032-DEL Software Configuration Manual page 927

Chapter 38 Configuring EtherChannels and Link-State Tracking
Beginning in privileged EXEC mode, follow these steps to assign a Layer 2 Ethernet port to a Layer 2
EtherChannel. This procedure is required.
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3 switchport mode {access | trunk}
switchport access vlan vlan-id
OL-13270-06
Purpose
Enter global configuration mode.
Specify a physical port, and enter interface configuration mode.
Valid interfaces include physical ports.
For a PAgP EtherChannel, you can configure up to eight ports of
the same type and speed for the same group.
For a LACP EtherChannel, you can configure up to 16 Ethernet
ports of the same type. Up to eight ports can be active, and up to
eight ports can be in standby mode.
Assign all ports as static-access ports in the same VLAN, or
configure them as trunks.
If you configure the port as a static-access port, assign it to only
one VLAN. The range is 1 to 4094.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring EtherChannels
38-13