Configuring The Switch As A Statically Connected Member; Configuring Optional Multicast Routing Features - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Optional Multicast Routing Features

To return to the default setting, use the no ip igmp query-max-response-time interface configuration
command.

Configuring the Switch as a Statically Connected Member

Sometimes there is either no group member on a network segment or a host cannot report its group
membership by using IGMP. However, you might want multicast traffic to go to that network segment.
These are ways to pull multicast traffic down to a network segment:
•
•
Beginning in privileged EXEC mode, follow these steps to configure the switch itself to be a statically
connected member of a group (and enable fast switching). This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 ip igmp static-group group-address
Step 4
end
Step 5 show ip igmp interface [interface-id]
Step 6 copy running-config startup-config
To remove the switch as a member of the group, use the no ip igmp static-group group-address interface
configuration command.
Configuring Optional Multicast Routing Features
These sections describe how to configure optional multicast routing features:
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
45-48
Use the ip igmp join-group interface configuration command. With this method, the switch accepts
the multicast packets in addition to forwarding them. Accepting the multicast packets prevents the
switch from fast switching.
Use the ip igmp static-group interface configuration command. With this method, the switch does
not accept the packets itself, but only forwards them. This method enables fast switching. The
outgoing interface appears in the IGMP cache, but the switch itself is not a member, as evidenced
by lack of an L (local) flag in the multicast route entry.
Features for Layer 2 connectivity and MBONE multimedia conference session and set up:
– Enabling CGMP Server Support, page 45-49
– Configuring sdr Listener Support, page 45-50
Features that control bandwidth utilization:
Configuring an IP Multicast Boundary, page 45-51
–
Procedure for configuring a multicast within a VPN routing/forwarding(VRF) table:
Configuring Multicast VRFs, page 39-88
–
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Configure the switch as a statically connected member of a group.
By default, this feature is disabled.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
(optional)
(optional)
(optional)
Chapter 45 Configuring IP Multicast Routing
(optional)
OL-13270-06