Preparing To Download Or Upload A Configuration File By Using Tftp; Downloading The Configuration File By Using Tftp - Cisco WS-CBS3032-DEL Software Configuration Manual

Working with Configuration Files

Preparing to Download or Upload a Configuration File By Using TFTP

Before you begin downloading or uploading a configuration file by using TFTP, do these tasks:
•
•
•
•
•
•

Downloading the Configuration File By Using TFTP

To configure the switch by using a configuration file downloaded from a TFTP server, follow these steps:
Copy the configuration file to the appropriate TFTP directory on the workstation.
Step 1
Verify that the TFTP server is properly configured by referring to the
Step 2
a Configuration File By Using TFTP" section on page
Log into the switch through the console port, the Ethernet management port, or a Telnet session.
Step 3
Download the configuration file from the TFTP server to configure the switch.
Step 4
Specify the IP address or hostname of the TFTP server and the name of the file to download.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
A-12
Appendix A
Ensure that the workstation acting as the TFTP server is properly configured. On a Sun workstation,
make sure that the /etc/inetd.conf file contains this line:
tftp dgram udp wait root /usr/etc/in.tftpd in.tftpd -p -s /tftpboot
Make sure that the /etc/services file contains this line:
tftp 69/udp
You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files.
Note
To restart the daemon, either stop the inetd process and restart it, or enter a fastboot
command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more
information on the TFTP daemon, see the documentation for your workstation.
Ensure that the switch has a route to the TFTP server. The switch and the TFTP server must be in
the same subnetwork if you do not have a router to route traffic between subnets. Check connectivity
to the TFTP server by using the ping command.
Ensure that the configuration file to be downloaded is in the correct directory on the TFTP server
(usually /tftpboot on a UNIX workstation).
For download operations, ensure that the permissions on the file are set correctly. The permission
on the file should be world-read.
Before uploading the configuration file, you might need to create an empty file on the TFTP server.
To create an empty file, enter the touch filename command, where filename is the name of the file
you will use when uploading it to the server.
During upload operations, if you are overwriting an existing file (including an empty file, if you had
to create one) on the server, ensure that the permissions on the file are set correctly. Permissions on
the file should be world-write.
Working with the Cisco IOS File System, Configuration Files, and Software Images
A-12.
"Preparing to Download or Upload
OL-13270-06