Classifying Traffic By Using Acls - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 37 Configuring QoS

Classifying Traffic by Using ACLs

You can classify IP traffic by using IP standard or IP extended ACLs; in Cisco IOS Release 12.2(52)SE
and later, you can use IPv6 ACLs. You can classify non-IP traffic by using Layer 2 MAC ACLs.
Beginning in privileged EXEC mode, follow these steps to create an IP standard ACL for IP traffic:
Command
Step 1 configure terminal
Step 2 access-list access-list-number {deny |
permit} source [source-wildcard]
Step 3 end
Step 4 show access-lists
Step 5 copy running-config startup-config
To delete an access list, use the no access-list access-list-number global configuration command.
This example shows how to allow access for only those hosts on the three specified networks. The
wildcard bits apply to the host portions of the network addresses. Any host with a source address that
does not match the access list statements is rejected.
Switch(config)# access-list 1 permit 192.5.255.0 0.0.0.255
Switch(config)# access-list 1 permit 128.88.0.0 0.0.255.255
Switch(config)# access-list 1 permit 36.0.0.0 0.0.0.255
! (Note: all other access implicitly denied)
OL-13270-06
Purpose
Enter global configuration mode.
Create an IP standard ACL, repeating the command as many times as
necessary.
For access-list-number, enter the access list number. The range is
•
1 to 99 and 1300 to 1999.
Use the permit keyword to permit a certain type of traffic if the
•
conditions are matched. Use the deny keyword to deny a certain
type of traffic if conditions are matched.
• For source, enter the network or host from which the packet is
being sent. You can use the any keyword as an abbreviation for
0.0.0.0 255.255.255.255.
(Optional) For source-wildcard, enter the wildcard bits in dotted
•
decimal notation to be applied to the source. Place ones in the bit
positions that you want to ignore.
When creating an access list, remember that, by default, the end
Note
of the access list contains an implicit deny statement for
everything if it did not find a match before reaching the end.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring Standard QoS
37-49