Supported Ipv6 Unicast Routing Features - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 40 Configuring IPv6 Unicast Routing
In the "Information About Implementing Basic Connectivity for IPv6" chapter, these sections apply to
the switch:
•
•
•
•

Supported IPv6 Unicast Routing Features

These sections describe the IPv6 protocol features supported by the switch:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Support on the switch includes expanded address capability, header format simplification, improved
support of extensions and options, and hardware parsing of the extension header. The switch supports
hop-by-hop extension header packets, which are routed or bridged in software.
The switch provides IPv6 routing capability over 802.1Q trunk ports for static routes, Routing
Information Protocol (RIP) for IPv6, and Open Shortest Path First (OSPF) Version 3 protocol. It supports
up to 16 equal-cost routes and can forward IPv4 and IPv6 frames simultaneously at line rate.
OL-13270-06
IPv6 Address Formats
IPv6 Address Type: Unicast
IPv6 Address Output Display
Simplified IPv6 Packet Header
128-Bit Wide Unicast Addresses, page 40-4
DNS for IPv6, page 40-4
Path MTU Discovery for IPv6 Unicast, page 40-4
ICMPv6, page 40-4
Neighbor Discovery, page 40-4
Default Router Preference, page 40-5
IPv6 Stateless Autoconfiguration and Duplicate Address Detection, page 40-5
IPv6 Applications, page 40-5
Dual IPv4 and IPv6 Protocol Stacks, page 40-6
DHCP for IPv6 Address Assignment, page 40-6
Static Routes for IPv6, page 40-7
RIP for IPv6, page 40-7
OSPF for IPv6, page 40-7
EIGRP for IPv6, page 40-7
HSRP for IPv6, page 40-8
SNMP and Syslog Over IPv6, page 40-8
HTTP(S) Over IPv6, page 40-8
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Understanding IPv6
40-3