Cisco WS-CBS3032-DEL Software Configuration Manual page 1046

Configuring Protocol-Independent Features
You can apply a policy route map to an EtherChannel port channel in Layer 3 mode, but you cannot
•
apply a policy route map to a physical interface that is a member of the EtherChannel. If you try to
do so, the command is rejected. When a policy route map is applied to a physical interface, that
interface cannot become a member of an EtherChannel.
You can define a maximum of 246 IP policy route maps on the switch or the switch stack.
•
You can define a maximum of 512 access control entries (ACEs) for PBR on the switch or the switch
•
stack.
When configuring match criteria in a route map, follow these guidelines:
•
To use PBR, you must first enable the routing template by using the sdm prefer routing global
•
configuration command. PBR is not supported with the VLAN and default templates. For more
information on the SDM templates, see
VRF and PBR are mutually exclusive on a switch interface. You cannot enable VRF when PBR is
•
enabled on an interface. The reverse is also true; you cannot enable PBR when VRF is enabled on
an interface.
• Web Cache Communication Protocol (WCCP) and PBR are mutually exclusive on a switch
interface. You cannot enable WCCP when PBR is enabled on an interface. The reverse is also true;
you cannot enable PBR when WCCP is enabled on an interface.
The number of hardware entries used by PBR depends on the route map itself, the ACLs used, and
•
the order of the ACLs and route-map entries.
Policy-based routing based on packet length, ToS, set interface, set default next hop, or set default
•
interface are not supported. Policy maps with no valid set actions or with a set action set to Don't
Fragment are not supported.
The switch supports QoS DSCP and IP precedence matching in PBR route maps, with these
•
limitations:
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
39-104
Do not match ACLs that permit packets destined for a local address. PBR would forward these
–
packets, which could cause ping or Telnet failure or route protocol flappping.
Do not match ACLs with deny ACEs. Packets that match a deny ACE are sent to the CPU, which
–
could cause high CPU utilization.
– You cannot apply QoS DSCP mutation maps and PBR route maps to the same interface.
You cannot configure DSCP transparency and PBR DSCP route maps on the same switch.
–
When you configure PBR with QoS DSCP, you can set QoS as enabled (by entering the mls qos
–
global configuration command) or disabled (by entering the no mls qos command). When QoS
is enabled, to ensure that the DSCP value of the traffic is unchanged, you should configure the
DSCP trust state on the port where traffic enters the switch by entering the mls qos trust dscp
interface configuration command. If the trust state is not DSCP, by default, all nontrusted traffic
has the DSCP value marked as 0.
Chapter 39
Chapter 8, "Configuring SDM Templates."
Configuring IP Unicast Routing
OL-13270-06