Ive Vpn Monitoring - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

IVE VPN Monitoring

618
Click the Save button to save the VPN configuration.
Verify the NHRP settings for the hub and spokes, virtual router, and spoke virtual
6.
router.
For interface NHRP settings:
7.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Interface. The Tunnel Interface dialog
box appears.
Click Protocol > NHRP. Ensure that the Enable NHRP check box is selected.
Click OK.
For the hub virtual router NHRP settings:
8.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Virtual Router. The Virtual Router dialog
box appears.
Click Dynamic Routing Protocol > NHRP > Parameters.
Verify that the ACVPN-Profile setting has been populated.
Click OK.
For the spoke virtual router NHRP settings:
9.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Virtual Router. The Virtual Router dialog
box appears.
Click Dynamic Routing Protocol > NHRP > Parameters.
Verify that the NHS IP Address field has been populated.
Click OK.
NSM real-time monitoring is available on Secure Access and Infranet Controller devices.
For more information, see "Realtime Monitoring" on page 649.
Copyright © 2010, Juniper Networks, Inc.