1700 Series Post Error Messages - HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual

1700 Series POST Error Messages

Table C-13: 1700 Series POST Error Messages
Error Code
1701-SCSI Controller
Failure
1702-SCSI Cable
Error Detected
1704-Unsupported
Virtual Mode Disk
Operation
DOS Driver Required
HP Servers Troubleshooting Guide
Audible Probable Source of
Beeps Problem
None Embedded SCSI
controller has failed or a
connected device is
preventing normal
operation.
None SCSI cable has failed.
None The operating system
currently running does
not support virtual DMA
service.
POST Error Messages
Action
1. Check SCSI cables and
be sure that they are fully
seated.
2. Be sure that SCSI IDs
are assigned correctly at
each SCSI device.
3. Remove SCSI cables
from the controller and
observe if the failure still
occurs. If necessary,
replace the cables.
4. Run Diagnostics.
5. Remove individual SCSI
devices from the cable to
identify a suspect device.
6. Replace failed assembly.
1. Reseat the SCSI cable
on the controller and all
connected devices.
2. Check the SCSI cable at
all connectors for bent
pins.
3. Replace SCSI cable.
Load or update the SCSI
device driver appropriate for
this operating system.
continued
C-47