HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 299

Index
RIS copies between drives do
not match D-14
RJ-45 receptacle, warning 2-2
ROM
accessing latest A-2
disaster recovery 5-2
possible failures 3-10
POST error messages C-4, C-6, C-7,
C-8, C-9, C-57
redundant image recovery 5-4
redundant, corrupted C-9
redundant, POST error messages C-9
remote flash problems 3-10, 3-11
remote flash, network connectivity
required 3-10
remote flash, procedures 3-10
remote flash, requirements 3-9
version, determining 1-16
ROM error C-7
ROM-Based Setup Utility See RBSU
ROMPaq
accessing A-4
described A-4
disaster recovery 5-2
website 3-11
run system configuration
utility - F10 key C-6
S
S.M.A.R.T. hard drive detects
imminent failure C-50
safety information 2-2
SCO OpenServer See Caldera and SCO
operating systems
SCO UnixWare See Caldera and SCO
operating systems
screen, blank 2-35, 2-36
screwdriver symbol 2-2
SCSI bus
cabling error D-17, D-19
door alert D-17
fan errors D-18, D-19
Index-24
firmware, unsupported D-18
overheating D-18
power supply failure D-17
SCSI cable error detected C-47
SCSI cable, POST error messages C-44,
C-45, C-47, C-48
SCSI controller failure C-47
SCSI controller test
failed B-14, B-15
SCSI controller, POST error messages C-47
SCSI devices See also devices
ID settings 2-26
POST error messages C-5
problems 2-26
SCSI disk erase tape test
failed B-13, B-15
SCSI disk ID drive types test
failed B-13
SCSI disk random read test
failed B-13
SCSI disk read test
failed B-13
SCSI disk SA/media test
failed B-13, B-15
SCSI disk unconditional format
test failed B-13
SCSI drives, storage fault recovery
tracking 5-19
SCSI hard drives, test error codes See also
hard drives
SCSI port X, Drive ID Y failed
– REPLACE (failure
message) D-14
SCSI port X, Drive ID Y
firmware needs
upgrading D-14
SCSI port X, Drive ID Y has
exceeded the following
threshold(s) D-15
SCSI port X, Drive ID Y is not
stamped for monitoring D-15
SCSI port X, Drive ID Y may
have a loose
connection D-15
HP Servers Troubleshooting Guide