Post Error Messages And Beep Codes; Introduction; Rompaq Disaster Recovery - HP ProLiant ML310 Generation 3 User Manual

POST error messages and beep codes

List of messages:

Introduction

..................................................................................................................................99
Introduction
For a complete listing of error messages, refer to the POST error messages in the
HP ProLiant Servers Troubleshooting Guide located on the Documentation CD
or on the HP website (http://www.hp.com/support).

ROMPaq disaster recovery

If the current version of the ROM is corrupt, perform ROMPaq disaster recovery
procedures:
1. Create a ROMPaq diskette using the Autorun Menu on the SmartStart CD.
2. Power down the server ("Powering down the server" on page 21).
3. Insert the ROMPaq diskette.
4. Power up the server ("Powering up the server" on page 21).
a. The server generates one long beep and two short beeps to indicate that
b. The ROMPaq diskette flashes the system ROM image. If successful, a
5. Power down the server ("Powering down the server" on page 21).
6. Remove the ROMPaq diskette.
WARNING: To avoid potential problems, ALWAYS read the
warnings and cautionary information in the server documentation
before removing, replacing, reseating, or modifying system
components.
you are in disaster recovery mode. If the diskette is not in place, the
system continues to beep until a valid ROMPaq diskette is inserted.
sequence of ascending audible beeps is generated. If unsuccessful, a
sequence of descending audible beeps is generated and you need to
repeat the disaster recovery process.
Troubleshooting 99