HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 200

POST Error Messages
Table C-4: 200 Series POST Error Messages
Error Code
209-Online Spare
Memory
Configuration-Spare
bank is invalid. Mixing
of DIMMs with
Primary Width of x4
and x8 is not allowed
in this mode.
209 - Mirror Memory
Configuration -
DIMMs on both
boards do not match.
209 - Mirror Memory
Configuration -
Single-Board Mirror
DIMMs do not match.
209-Mirror Memory
Configuration - Board
2 present in Single-
Board Mirror.
211-Invalid Processor
Board PPM installed,
Module X
211-Invalid Processor
PPM installed,
Module X
211-Invalid Voltage
Regulator Module
installed for Processor
X
212-Processor Failed,
Processor X
212-System
Processor
Failed/Mapped out
C-20
Audible Probable Source of
Beeps Problem
1 long, Installed DIMMs for
1 short online spare bank are of
a different primary width
than the DIMMs in other
banks.
1 long, Memory boards are not
1 short populated identically, or a
memory board is missing.
1 long, Mirrored banks are not
1 short populated identically, or
memory board 1 is
missing.
1 long, A second memory board
1 short is installed in the single-
board mirrored memory
configuration.
None Wrong PPM installed.
None Wrong PPM installed.
None Nonredundant Processor
Power Module (PPM)
installed in indicated
processor slot.
1 short Processor in slot X failed.
1 short Processor in slot X failed.
continued
Action
Install or reinstall DIMMs to
support online spare
configuration.
Be sure that two memory
boards are installed and that
DIMMs are populated
correctly.
Be sure mirrored banks are
populated identically and that
only memory board 1 is
installed.
Remove memory board 2.
Replace processor PPM.
Replace processor PPM.
Replace with a PPM that
supports redundancy.
Run Diagnostics and replace
failed processor.
Run Diagnostics and replace
failed processor.
HP Servers Troubleshooting Guide
continued