HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 233

Table C-13: 1700 Series POST Error Messages
Error Code
1728-Drive Array-
Abnormal Shut-Down
Detected With Write-
Cache
1729-Slot 1 Drive
Array – Performance
Optimization Scan In
Progress.
RAID 4/5/ADG
performance may be
higher after
completion.
1730-Fixed Disk 0
does not support
DMA Mode
1731-Fixed Disk 1
does not support
DMA Mode.
1740-Fixed Disk 0
failed Set Block Mode
command
1741-Fixed Disk 1
failed Set Block Mode
command
1750- Fixed Disk X
failed ID command
1750-Fixed Disk X
failed Identify
command
HP Servers Troubleshooting Guide
Audible Probable Source of
Beeps Problem
None There is no array
accelerator battery
backup on this array
controller but caching
was enabled. Any data
that may have been in
array accelerator memory
has been lost due to the
controller power loss.
None RAID 4/5/ADG parity
drive(s) are being
initialized.
None Fixed disk drive error
detected.
None Fixed disk drive error
detected.
None Fixed disk drive error
detected.
None Fixed disk drive error
detected.
None Fixed disk drive error
detected.
None Fixed disk drive error
detected.
continued
Action
Restore data from backup.
This message is normal
following the initial
configuration of RAID 4 or
RAID 5 logical drives.
Performance of the controller
improves after the parity data
has been initialized by ARM
(an automatic process that
runs in the background on the
controller).
Run the server setup utility
and correct.
Run the server setup utility
and correct.
Run the server setup utility
and correct.
Run the server setup utility
and correct.
Run the server setup utility
and correct.
Run the server setup utility
and correct.
POST Error Messages
continued
C-53