Diagnostics On A 64-Bit System - HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual

Diagnostic Tools
Running Diagnostics
To run Diagnostics from the partition:
•
If your server uses ROM-Based Setup Utility (RBSU), press the F10 key when
prompted during the boot process. A menu is displayed listing Test Computer
and Inspect Computer. Select Test Computer.
•
If your server uses System Configuration Utility (SCU):
a. Power up the server, and then press the F10 key when the following message
is displayed:
Press F10 for system partition utilities
b. Select Diagnostics and Utilities from the SCU main menu.
c. Select Test Computer to run Diagnostics.
If your system does not have a partition set up, a Diagnostics diskette is required to
run Diagnostics. To run Diagnostics from a Diagnostics diskette, boot the server with
the Diagnostics diskette in drive A. A Diagnostics diskette can be made by running
the Server Diagnostics file available for download from the following website:
www.compaq.com/support/files/server
Select your server and operating system, and then select the Server Diagnostics file
from the Utilities section on the website.

Diagnostics on a 64-bit System

Diagnostics for 64-bit systems must be run from an LS-120 Diagnostics Diskette.
Running Diagnostics
To create and use the LS-120 diskette:
1. Download the SoftPaq to a directory on your hard drive. The SoftPaq file is a
self-extracting executable with a filename based on the SoftPaq number, and can
be downloaded from the following website:
www.compaq.com/support/files/server
4-6 HP Servers Troubleshooting Guide