Running Inspect On A 64-Bit System - HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual

•
If your server uses the System Configuration Utility (SCU):
a. Power up the server, and then press the F10 key when the following message
is displayed:
Press F10 for system partition utilities
b. Select Diagnostics and Utilities from the SCU main menu.
c. Select Inspect Computer to run Inspect.
If your system does not have a partition set up, a Diagnostics diskette is required to
run Inspect. To run Inspect from a Diagnostics diskette, boot the server with the
Diagnostics diskette in drive A. A Diagnostics diskette can be made by running the
Server Diagnostics file available for download from the following website:
www.compaq.com/support/files/server
Select your server and operating system, and then select the Server Diagnostics file
from the Utilities section on the website.
When Inspect has been initialized, select a hardware option for information about that
device.

Running Inspect on a 64-bit System

On a 64-bit system, Inspect can be run from within Diagnostics by selecting Inspect
Information from the main menu. Refer to the "Diagnostics on a 64-bit System"
section in this chapter for more information on running Diagnostics.
Inspect can also be run from the EFI Boot Manager. From the main menu in EFI
Boot Manager, select the System Maintenance menu, and then select System
Inspect Menu.
HP Servers Troubleshooting Guide
Diagnostic Tools
4-11