HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 255

Table D-1: Array Diagnostic Utility (ADU) Error Messages
Message
Adapter/NVRAM ID mismatch
Array accelerator battery pack
X not fully charged
Array accelerator battery pack
X below reference voltage
(recharging)
Board in use by expand
operation
Board not attached
Cache has been disabled
because ADG Enabler Dongle
is broken or missing.
Cache has been disabled;
likely caused by a loose pin on
one of the RAM chips.
HP Servers Troubleshooting Guide
Description
EISA nonvolatile RAM
(NVRAM) has an ID for a
different controller from the
one physically present in the
slot.
Battery is not fully charged.
Battery pack on the array
accelerator is below the
required voltage levels.
Array accelerator memory is in
use by an expand operation.
An array controller is
configured for use with array
accelerator board, but one is
not connected.
The cache has been disabled
because RAID ADG volume is
configured but the ADG
Enabler Dongle is broken or
missing.
Cache has been disabled due
to a large number of ECC
errors detected while testing
the cache during POST. Likely
caused by a loose pin on one
of the RAM chips.
ADU Error Messages
continued
Recommended Action
Run the server setup utility.
If 75% of the batteries present
are fully charged, the array
accelerator is fully operational.
If more than 75% of the
batteries are not fully charged,
allow 36 hours to recharge
them.
Allow enough time for batteries
to recharge (36 hours). If
batteries have not recharged
after 36 hours, replace the
array accelerator board.
Operate the system without
the array accelerator board
until the expand operation
completes.
Connect array accelerator
board to array controller.
Check the ADG Enabler
Dongle. Replace if needed.
Try reseating the cache to the
controller. If that does not
work, replace the cache.
continued
D-5