HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 229

Proliant server troubleshooting guide
Hide thumbs Also See for 1850R - ProLiant - 128 MB RAM:
Table of Contents

Advertisement

Table C-13: 1700 Series POST Error Messages
Error Code
1713-Slot z Drive
Array Controller -
Redundant ROM
Reprogramming
Failure Replace the
controller if this error
persists after
restarting system.
1714-Slot z Drive
Array Controller -
Redundant ROM
Checksum Error
Backup ROM has
automatically been
activated. Check
firmware version.
1720-Slot X Drive
Array – S.M.A.R.T.
Hard Drive(s) Detect
Imminent Failure
SCSI: Port Y:
SCSI ID Z.
HP Servers Troubleshooting Guide
Audible
Probable Source of
Beeps
Problem
None
Flash ROM is going bad.
Controller detected a
checksum failure but is
unable to reprogram the
backup ROM.
None
Controller flash operation
interrupted by power-
cycle, or flash ROM may
be going bad.
None
Hard drive predictive
failure condition detected.
continued
Action
Replace controller when
possible, or try upgrading
firmware using Options
ROMPaq.
Controller has detected a
ROM checksum error and
automatically switched to the
backup ROM image. Upgrade
controller firmware using
Options ROMPaq if this
backup ROM image is a lower
version than that originally
running.
The indicated drive has
reported a SMART predictive
failure condition. It may fail at
some time in the future.
If this drive is part of a
non-fault-tolerant
configuration, back up all
data before replacing the
drive and restore all data
afterward.
If this drive is part of a
fault-tolerant
configuration, do not
replace this drive unless
all other drives in the
array are online.
POST Error Messages
continued
C-49

Advertisement

Table of Contents
loading

Table of Contents