Configuring Is-Is Basic Functions - 3Com Switch 4800G 24-Port Configuration Manual

Configuring IS-IS Basic
Functions
Configuration
Prerequisites
Configuration Procedure
Task
"Configuring IS-IS Routing
Information Control" on page 342
"Tuning and Optimizing IS-IS
Network" on page 346
"Configuring IS-IS GR" on page 352
Before the task, configure an IP address for each interface, making all adjacent
nodes reachable to each other at the network layer.
Follow these steps to configure IS-IS basic functions:
To do...
Enter system view
Enable IS-IS routing process
and enter its view

Configuring IS-IS Basic Functions

"Specifying a Priority for IS-IS" on page 342 Optional
"Configuring IS-IS Link Cost" on page 343
"Configuring the Maximum Number of
Equal Cost Routes" on page 344
"Configuring IS-IS Route Summarization" on
page 344
"Advertising a Default Route" on page 345
"Configuring Inbound Route Filtering" on
page 345
"Configuring Route Redistribution" on page
345
"Configuring IS-IS Route Leaking" on page
346
"Configuring a DIS Priority for an Interface"
on page 346
"Configuring IS-IS Timers" on page 347
"Disabling an Interface from
Sending/Receiving IS-IS Hello Packets" on
page 347
"Configuring LSP Parameters" on page 348
"Configuring SPF Parameters" on page 349
"Configuring Dynamic Host Name
Mapping" on page 349
"Configuring IS-IS Authentication" on page
350
"Configuring LSDB Overload Tag" on page
351
"Logging the Adjacency Changes" on page
351
"Enabling an Interface to Send Small Hello
Packets" on page 351
"Enabling SNMP Trap" on page 352
Use the command...
system-view
isis [ process-id ]
341
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
--
Required
Not enabled by default