Communication Setting At The Support Tool; Data Communication Procedure - Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Communication Setting at the Support Tool

11-1-3 Data Communication Procedure

11-2 Communication Setting at the Support Tool

Operation procedure
430
ISO-8859 are displayed on the Support Tool but they are not available on a
PT (16x16 font and CP437 font type are used on the PT).
Note) If the vendor (manufacturer) of the PLC you are using and the PLC ven-
dor setting of the created screen data is different, transmission is not pos-
sible. The following message is displayed.
Memory access mismatched: communication aborted
The procedure for transmitting data between a PT and the Support Tool is indi-
cated below.
Setting for communications at Support Tool
Set the RS-232C port and baud rate at the Support Tool (personal computer).
Set PC (PLC) to Transmit mode
Place the PT in the Transmit mode to allow communications of the data be-
tween the PT and the personal computer.
For details of this procedure at PT, refer to the User's Manual of your PT.
Selecting the data to be sent/received
From the menu at the Support Tool, select the direction of data transmission
(download/upload) and the kind of data to be transmitted. Depending on the
data, more detailed selection may be possible.
After the data has been determined, data transmission will start.
Set the baud rate and communication port at the Support Tool (personal comput-
er)
(1) Select [Connect] (menu bar)
The communication dialog box is displayed.
(2) Set the data for the displayed items.
The meanings of the items are described below.
[Comms. Setting].
Section 11-2