Arc - Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Fixed Display

6-2-2 Arc

Operation procedure
Terminology
Property setting
138
(3) Drag the vertex to the desired position.
Cursor position
[Remove Node]
executed
S To remove a vertex, locate the cursor on the vertex to be removed and select
[Remove Node] in the pop-up menu.
An arc is drawn.
Arcs cannot be used with NT11S/NT11, NT20, NT20S and NT600S.
(1) An arc is drawn. The radius of an arc can be changed.
Selection using the menu bar:
Selection using the drawing toolbar:
Center point
Start point
General
Position
Center point: Indicates the position of the center of an arc.
Start point: Indicates the position of the start point of an arc.
[Objects] [Fixed Display]
End point
Section 6-2
[Arc]