Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 500

NT Transfer Utility
(4) Input "a:\setup" in the input field in the specified window.
Note that drive designation must agree with the name of the drive where you
set the system disk. If you set the disk in drive B, input "b: \ setup." In case of
CD-ROM, click on
the Transfer Utility folder.
(5) Click on .
The installation started.
(6) When the setup screen of the NT Transfer Utility is displayed, click on
.
The screen for specifying the destination of program installation is dis-
played.
(7) Specify the directory for installation.
In the initial state, the directory shown below is set as the destination directo-
ry.
C: \Program Files\Omron\Ntst4.8E\Transfer Utility
If you want to change the directory, click on
directory. (If a directory that does not exist in the hard disk is specified, the
directory is automatically made.)
After specifying the destination, click on
The screen for specifying the destination for registering the start menu is dis-
played.
(8) In the start menu of Windows, specify the folder where the short-cut to the
Support Tool is created.
In the initial state, the following folder is selected.
Start\Program\Omron\Ntst4.8E
and specify SETUP.EXE in the disk1 folder in
and input the drive and
.
Appendix C
493