Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 443

Sending (Downloading) the Data
Reference: S When data is sent from the Support Tool to a PT, the existing data in the PT is
Operation procedure
432
Data Type
*1
System Memory
*2
Table
*1: With the NT21, NT31, NT31C, NT631 and NT631C, individual transmission
of system memory is restricted as follows:
The following data stored in a PT cannot be overwritten.
S Number of numeral table entries
S Number of string table entries
S Number of bit memory table entries
S Screen history setting
S Alarm history setting
S Numeral storage type
The following data can be overwritten.
S Initial screen number
S Screen data comment
*2: You cannot transmit the mathematical table separately. The mathematical
table will be transmitted only when application transmission is performed.
lost. Therefore, make sure that the existing data in the PT is backed up by the
Support Tool before executing data transmission from the Support Tool to the
PT.
S With the Support Tool on CD-ROM, NT Transfer Utility that is exclusively used
for downloading/uploading the screen data is supplied (For details, refer to Ap-
pendix C).
(1) Select [Connect] (menu bar)
Description
The setting contents of "System" of "PT Config-
uration" are sent and set at the PT.
NT20, NT20S and NT600S:
The following data is sent in a batch.
S Numeral memory table data
S Character string memory table (String table)
data
S Mark data
NT21, NT31, NT31C, NT631, and NT631C:
The following data can be sent individually.
S Numeral memory table
S Character string memory table (String table)
S Bit memory table
S Mark data
S Image data
S Library data
S Recipe table
[Download (NT-series Support Tool
Section 11-3
PT)].