Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 245

Graphs
232
S Meter shape is displayed as follows according to the width rate.
Width Rate: 10% Width Rate: 50%
S Scale position and its shape are displayed as follows depending on the set-
tings of [Distance], [Scale Length].
Scale
Distance: 0% Distance: 100%
Length
10%
50%
100%
Scale is always displayed at the front of meter. Therefore, when type is set to a
Needle, the needle may be invisible if meter and scale are overlapped.
S When the Display Sign is set to ON, specified No. of division is applied also for
a negative range. Therefore, actual numbers of division differs as follows de-
pending on the presence/absence of display sign even if the specified number
of divisions is same.
Example: In case No. of division is 5
Display Sign: ON
S In the default setting, a percentage value is displayed.
Whether or not a percentage value is displayed can be set in the [Display La-
bel] property.
Check mark set:
Check mark not set:
S If the setting for a percentage value is displayed, the size and display position
of the value can be modified using the element edit function in the manner
shown below. (For detail of the element edit function, refer to page 110.)
(1) Click on a percentage value while pressing the Shift key and Ctrl key.
(2) Drag a percentage value to change the display position.
Width Rate: 100%
Distance: 150%
Display Sign: OFF
A percentage value is displayed.
A percentage value is not displayed.
Section 6-9