Batch Address Change Operation - Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Common Operation

7-1-3 Batch Address Change Operation

Description of batch address change dialog box
270
(6) Click on
The set PC (PLC) addresses can be changed into the required addresses in a
batch. Since the change source can be specified as a range, processing such as
changing the address range DM1000 to DM01499 to the address range DM1800
to DM2299 is possible at one time. Shifting in bit units is also possible.
Note that the batch address change operation is allowed only for displayed table
entries.
Independent with the location of the cursor, this address change will be per-
formed to the whole table.
Find – Channel (Word)
Specify the word type of the batch change source.
Find – Start Range
Specify the start address of the source range for the batch address change.
Find – End Range
Specify the end address of the source range for batch address change.
The address to be set for [End Range] must always be larger than or equal to the
address set for [Start Range].
or .
D00000
D00030
Section 7-1