Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 501

NT Transfer Utility
Uninstall
494
If you want to change the folder, select the desired folder from the Existing
Folders or directly input the folder name. (If a folder that does not exist in the
hard disk is specified, the specified folder is automatically made.)
After specifying the folder, click on
Installation of the specified programs is implemented; files are copied.
During program installation, the progress of the processing is indicated as a
percentage.
(9) After the completion of installation, the folder specified in step (8) is dis-
played along with the installation completion message.
Click on , then click on
Installation operation is completed.
An uninstaller (uninstall software) is supplied with the NT Transfer Utility.
If you want to remove the NT Transfer Utility from your personal computer, run
the uninstaller to delete the NT Transfer Utility program files and installation in-
formation. (Note that the data saved by the NT Transfer Utility is not deleted.)
S Starting the uninstaller from the Windows start menu
Select "Uninstall Transfer Utility" in the same folder where the short-cut to the
Support Tool is stored.
Example:Assuming the short-cut to the Support Tool exists in the Start\Pro-
gram\Omron\NTST4.8E\Uninstall Transfer Utility folder
Select the uninstaller by the following operation.
[Start] [Program]
Utility]
After the start up of the uninstaller, follow the instructions displayed on the
screen.
.
in the setup completion screen.
[Omron] [NTST4.8E]
Appendix C
[Uninstall Transfer