Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 435

Quick Reference
Item
Operations To copy the screen data
To copy image/library data (1) Selected the code to be copied on the image/library
To group several graphics
into one graphic
To specify the graphic that
is behind another ele-
ment/graphic
To display only the se-
lected type of element to
facilitate the screen edit-
ing of complicated screen
To align the position of the
graphics correctly
424
Operation
(1) Using the application manager, select the file of the
screen to be copied.
(2) [Edit] [Copy]
(3) [Edit] [Paste]
(4) Specify the copy destination screen number.
(1) Display the copy source screen.
(2) [Edit] [Select All]
(3) [Edit] [Copy]
(4) Open the copy destination screen.
(5) [Edit] [Paste]
If screen data of the same PT model setting is opened by
[Import Component] from the [File] menu, copy & paste
operation above is possible between the Support Tools.
table entry.
(2) [Edit] [Copy]
(3) Select the code to be pasted.
(4) [Edit] [Paste]
If screen data of the same PT model setting is opened by
[Import Component] from the [File] menu, copy & paste
operation above is possible between the Support Tools.
(1) Select all graphics to be grouped.
(2) [Draw] [Group]
Note Use the following commands to ungroup the grouped
graphics: [Draw]
Click the different position so that the graphic at the back
side is selected.
Note The element with the smallest area enclosing the point
of selection will be selected.
(1) Select the graphic at the front side.
(2) [Draw] [Send to Back]
(3) Specify the graphic brought to the front side.
(1) Select the graphic at the front side.
(2) [Edit] [Select Object]
(3) Select the graphic to be specified in the list.
Keep pressing the Tab key (or Shift key + Tab key) until the
objective graphic is selected.
Specify the objective type of element on a filter and select
the graphic by the method above.
Specify the type of element to be displayed using a filter
(on the utility bar). (During the filter function, only the dis-
played element can be edited.)
(1) Select all the graphics to be aligned.
(2) [Edit] [Align] and select the aligning method.
[Ungroup]
Section 10-1
Refer to
4-2
6-1-5
3-3-6
8-1
8-2
3-3-6
6-1-7
6-1-3
6-1-5
6-1-3
6-1-3
5-1-4
5-1-4
6-1-6