Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 164

Fixed Display
Property setting
Guidance
General
Position: Indicates the display position of image data.
(The reference point is at the upper left corner in the image ele-
ment.)
Size: Indicates the size of image data.
Reference Type
Direct: Set the image code directly.
Code: Indicates the code number of the image data to be displayed.
Mode: Indicates the color mode of the image data (2 colors, 8 colors).
Comment: Displays the comment that is set for the image data.
Indirect: Set this item when the value for the specified numeral table
entry is treated as image code and referenced indirectly.
Table No.: Specify the numeral table entry to be referenced.
When using the indirect reference, set the storage type of allo-
cated numeral table entry to Binary. Also, when specifying the
image code from a program etc., use hexadecimal value since
the image table code is in hexadecimal.
Color
Foreground: Set the display color of image data.
(Setting is possible only when 2 colors is set for the color
mode.)
Background: Set the color of background in the image data display area.
(Setting is possible only when 2 colors is set for the color
mode.)
: Displays the list for selecting the image data when Direct is
specified. Displays the list for referencing the numeral table
entry when Indirect is specified.
S When the image data is firstly specified, the data of character code FE20H (for
the NT30, NT30C, NT620S, NT620C, NT625C and NT21 and NT31/631-V2
and above with NT20/30/620-compatible mode), or the data that corresponds
to image/library code 0001H (for the NT21, NT31, NT31C, NT631, NT631C
without NT20/30/620-compatible mode) is arranged as default.
S The mark shown below will be displayed if image data has not been created for
the specified code.
S To change the image data to be displayed, click on
lect the desired image data or numeral table entry from the list.
If you are using the NT31, NT31C, NT631 or NT631C "-V1" and above, and its
system program version is 2.1 and above, "Indirect reference" can be set.
The procedure for specifying the desired image data is shown below.
Direct
Specify the code of the image data to be displayed directly.
Section 6-2
in the property and se-
151